> If the worse case scenario happened, and the bridge pins needed to be > reinforced with epoxy, could the entire repair be done in 24 hours? No. (Or at least not by me!) I have always used original bridge pin sizes and had very good luck with outcome. Terry Farrell ----- Original Message ----- From: "Bill Ballard" <yardbird@pop.vermontel.net> To: <pianotech@ptg.org> Sent: Saturday, July 20, 2002 11:46 PM Subject: Overnight Bridge Repair > Dear List, > > I've got a big piano (no, another one) with very wobbly notes on > either side of the mid-treble break. Wobbly in sound and in pitch > stability. The common description would be false beats, but also low > sustain. The whole board is great, and I'm confident that that if > both terminations are solid, that region will be too. > > If the worse case scenario happened, and the bridge pins needed to be > reinforced with epoxy, could the entire repair be done in 24 hours? I > don't think so. Count the steps: slack and clear strings away, pull > old bridge pines, test new pin size, size hole with epoxy, drive and > finish pins pins, cure resin, restring through stable. I don't think > so. > > I already have a long list of things that I've checked. But others > might like the list. > > Bill Ballard RPT > NH Chapter, P.T.G. > > "If ducks were smart enough and well-built enough, they'd be shooting > at us. It's not my fault they can't aim and shoot." > ...........Talk Show host Rush Lamebaugh, explaining why duck > hunting is a sport, 1/12/98 > +++++++++++++++++++++
This PTG archive page provided courtesy of Moy Piano Service, LLC