Oh...I thought you were talking about the wood screws holding the brass rail to the action rail...duh...I HAD THE EXACT SAME PROBLEM WITH A SET OF BUTT PLATES I RECEIVED FROM SCHAFF! sorry for shouting but that just came to me. Sorry I sounded like an idiot David I. ----- Original message ----------------------------------------> From: Joseph Garrett <joegarrett@earthlink.net> To: <pianotech@ptg.org> Received: Thu, 27 Jun 2002 19:08:20 -0700 Subject: RE: Knabe Upright/David Ilvedson part II=screws >David, >Nipping off a wood screw can oft-times work just fine. Just not the same as >a threaded machinist screw thread. On bigger one's of that type it is >possible to trim them and "chase the thread and put a slight bevel on the >tip. But, on those tiny little puppies, I wouldn't do it. Too much like a >make work project, to me. >As for doing all of the rails, yes. >Best Regards, >Joe Garrett, RPT, (Oregon)
This PTG archive page provided courtesy of Moy Piano Service, LLC