My Shop as a Strip Joint

[JIMRPT@aol.com]

In a message dated 16/04/03 11:03:30 AM, tune4u@earthlink.net writes:

<< Should I just strip and sand and work with whatever I get, restaining or

such? >>

Alan;
 Stripping will remove some stain also. Just get the pieces as clean as you 
can and sand well using 180/220 paper. Watch all the edges so that you don't 
round them off. 
 Stain each piece to match your desires.... it will be easier than you think. 
:-)
Jim Bryant (FL)