Thanks, that was my assumption. Alan -----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org]On Behalf Of Ron Nossaman Sent: Friday, April 25, 2003 8:34 AM To: Pianotech Subject: Re: Shark PreFiling >The Ronsen Company order sheet has an item "Hammerheads Prefiled." > >Does this refer to felt removal or tapering grand heads to avoid collisions >and/or reduce mass? > >Alan Barnard When hammers are sliced apart after pressing, the (hopefully) internal compression makes the edges flare out. This leaves a cup down the center of the outer surface of the hammer, including the strike point. Prefiling just removes the cup and squares the outer surface of the hammer to the sides. It has to be done, whether they do it before you get the hammers, or you do it afterward - either before or after hanging them. That's all it is. Ron N _______________________________________________ pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC