Does anyone have any plans available for these presses? Or do I need to find Clairs' Journal articles? Mike Bratcher ----- Original Message ----- From: "Delwin D Fandrich" <pianobuilders@olynet.com> To: "Pianotech" <pianotech@ptg.org> Sent: Friday, August 08, 2003 12:02 PM Subject: Re: Pneumatic Soundboard Press > > ----- Original Message ----- > From: "Farrell" <mfarrel2@tampabay.rr.com> > To: "Pianotech" <pianotech@ptg.org> > Sent: August 08, 2003 3:36 AM > Subject: Re: Pneumatic Soundboard Press > > > > Don't you get a fair bit of bending of your bottom caul when clamp is > pressurized? Or did you figure that into your caul curve. That would be a > bit of a stroke of genius. > > Precious little. > No. > Precious little. > > > > > > If/when I make a second generation of clamps, they will certainly look > very different from my clunky-but-functional ones. > > I'll not hold my breath. Once made these things rarely get replaced. We > made a set of these for someone else once. Before starting the project I > tried to estimate what they would cost--I was shocked. And I didn't > overestimate. No, not at all. Once you figure up what you have invested in > yours--planning and building time, materials, assembly time, etc.--you'll > be shocked as well. > > Del > > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC