List An old Kimball 6'7" grand came in for a "redo." The plate hole for the tuning pin bushings mikes at .470." The available bushings are 7/16" which is .436" O.D. Has anyone had this problem and, if so, how did you solve it? Is there any danger in leaving the bushings out? Right now, the piano is still strung and up to pitch, but there is a continuous gap between the plate flange and pinblock The new block will be carefully fitted to the flange and plate. What are your thoughts? Paul Chick
This PTG archive page provided courtesy of Moy Piano Service, LLC