pedals

[Joe And Penny Goss]

Hi Brian, For an exact fit the first time use the 1/4" dowel cut into two
pieces just shorter than the length you want. Then insert both short dowels
into the hole or notch and mark the end of one dowel as it lays across the
other.
Remove from socket hole and use the two dowels to locate the measurement for
the real thing.  Be careful to be sure that the lyre assembly is even and
where you want it to end up.
Joe Goss
imatunr@srvinet.com
www.mothergoosetools.com
----- Original Message -----
From: "Brian Trout" <brian_trout@hotmail.com>
To: <pianotech@ptg.org>
Sent: Wednesday, January 29, 2003 4:06 PM
Subject: RE: pedals


> Hi Brian,
>
> I noticed you didn't get much response from your earlier post, so I'll
offer
> a suggestion.
>
> How hard would it be to measure the length you need?  You may need to
> disassemble the pedal lyre to determine what's inside the lyre box and if
> you'll be needing to do some refelting, etc.  (That'll change the
dimension
> slightly.)  Also, have a look at what's on the underside of the keybed.
> Those felts that are at the top of the lyre rods may need replaced at the
> same time.
>
> If you want something to substitute for the pedal rods that you can
> calculate with and even mess up that won't cost much, get yourself a few
> 1/4" wooden dowels from the hardware store.  Cut each of them to fit in
> where the rod will go to as close to the dimension you think you'll need
as
> you can.  (Hint... it's easy to cut more off, it's hard to reattach...) If
> you get it a little short, make note of it on the rod so you can cut the
> real one that much longer.  Mark one for each pedal rod.  (They're
probably
> all a slightly different length.)
>
> Use the wooden dowels as patterns for some 1/4" (or whatever size you
think
> might have been close to the original) brass rod.  Cut to length, polish,
> lacquer, install, and be the hero of the day.  You may need some pieces of
> felt as shims if you get the rods a bit too short.  A lot will depend on
how
> well you measure and think things out before you cut.  And when you're
done,
> keep the dowels around.  You'll use them for something!
>
> Just one possibility of several.
>
> Good luck,
>
> Brian T.
>
>
>
>
>
>
>
> >From: Brian Doepke <doepkeb@comcast.net>
> >Reply-To: doepkeb@comcast.net, Pianotech <pianotech@ptg.org>
> >To: "'Pianotech'" <pianotech@ptg.org>
> >Subject: RE: pedals
> >Date: Wed, 29 Jan 2003 16:17:07 -0500
> >
> >I got a call from a lady who misplaced the brass rods to her baby grand
> >when they moved to my town.  The lyre for the pedals is the kind that
> >has a large wooden block where the top and the bottom of the rods are
> >inserted.  The back of the pedals are not exposed.  I can't use the
> >adjustable brass rods with the barrel on one end.
> >
> >Is she out of luck?  If not, how difficult is it to replace the set?
> >
> >BD
>
>
> _________________________________________________________________
> MSN 8 with e-mail virus protection service: 2 months FREE*
> http://join.msn.com/?page=features/virus
>
> _______________________________________________
> pianotech list info: https://www.moypiano.com/resources/#archives