This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Message -----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org]On Behalf Of Keith Roberts Sent: Wednesday, July 30, 2003 9:34 PM To: doepkeb@comcast.net; Pianotech Subject: Re: Formula Tuning pins are all over the map and depends on who made them. And they are not accurate enough to use them without measuring. I just saw a box being measured and some you would throw in box of the next size up because they were that much larger. Keith Robert [Paul Chick (Earthlink)] Keith I miked a box of Denro 2/0 x 2 3/8" Blued tuning pins just 3 weeks ago. They varied in size by .0015". I could not feel the difference in pin torque after installation, but I did not measure torque-didn't see the need. Felt consistant throughout. Paul C ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/bc/60/91/64/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC