Hmm? Was there a message in either of these posts that I've missed. Or are you learning my tricks? Del ----- Original Message ----- From: "gordon stelter" <lclgcnp@yahoo.com> To: "Pianotech" <pianotech@ptg.org> Sent: March 03, 2003 10:06 AM Subject: Dust-free finishing for soundboards. > > --- Delwin D Fandrich <pianobuilders@olynet.com> > wrote: > > > > ----- Original Message ----- > > From: "gordon stelter" <lclgcnp@yahoo.com> > > To: "Pianotech" <pianotech@ptg.org> > > Sent: March 03, 2003 6:26 AM > > Subject: Re: Drying pinblock before stringing-slight > > clarification. > > > > > > > I still disagree, Ken. As I have experienced > > plenty of > > > pianos develop looser pins in winter, when the > > > humidity is low, I believe that this will "open > > up" > > > the holes a little prior to stringing, preventing > > some > > > fiber tear on pin pounding and then the pin will > > be a > > > little tighter when the EMC rises. As I am not > > going > > > to test this scientifically, and as I am a > > neurotic > > > compulsive perfectionist with a "better safe than > > > sorry"-"do my very best for the customer" complex, > > I > > > will continue this practice until someone shows me > > > hard scientific evidence, not just their opinion, > > that > > > it is worthless. > > > Have a Nice Day! > > > Thump > > > > Well, it is a fairly well researched and documented > > fact that a hole of > > given size in a piece of wood expands and contracts > > along with the expansion > > and contraction of the wood. This is Basic Wood > > Technology 101. Check R. > > Bruce Hoadley's 'Understanding Wood' for details. > > > > So, since the change in tuning pin torque you are > > finding is also real and > > well documented, there must be some other mechanism > > at work here. > > > > Since this subject comes up from time to time there > > is an accumulated (and > > accumulating) amount of information in the archives. > > One I have brought up > > in the past (others as well, I expect) is that the > > coefficient of friction > > between the metal pin and the wood surface changes > > as the moisture content > > of the wood changes. It decreases as the moisture > > content goes down and > > increases as the moisture content goes up. I've no > > idea if this change is > > enough to account for the variation in tuning pin > > torque felt in some pianos > > but, if it were a question I was interested in > > enough to do some research > > answering, this is where I'd start.... > > > > Del > > > > > > _______________________________________________ > > pianotech list info: > https://www.moypiano.com/resources/#archives > > > __________________________________________________ > Do you Yahoo!? > Yahoo! Tax Center - forms, calculators, tips, more > http://taxes.yahoo.com/ > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC