Outfit the beam with electrical contacts to feed the
values automatically!
Thump
--- Richard Brekne <Richard.Brekne@grieg.uib.no>
wrote:
>
>
> gordon stelter wrote:
>
> > This tool could be used with a bell crank to
> function
> > properly in its preferred horizontal orientation,
> set
> > up on a stand for uniformity.
> > Hey! Why not a calibrated beam on a pivot, on
> a
> > stand, with sliding weights? As the weights were
> slid
> > along the beam to the correct point, down and
> upweight
> > measurements could be very easily and accurately
> > taken. Anyone doing this?
> > Thump
>
> I dont know, but I think I would sure like to get
> ahold of one of these
> things. And I like the idea of automatically being
> able to pump values
> into a puter. Nice idea for sure.
>
> --
> Richard Brekne
> RPT, N.P.T.F.
> UiB, Bergen, Norway
> mailto:rbrekne@broadpark.no
> http://home.broadpark.no/~rbrekne/ricmain.html
> http://www.hf.uib.no/grieg/personer/cv_RB.html
>
>
> _______________________________________________
> pianotech list info:
https://www.moypiano.com/resources/#archives
__________________________________
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo.
http://search.yahoo.com
This PTG archive page provided courtesy of Moy Piano Service, LLC