thanks Ron. I had tried my capstain tool, but the end stuck through the eye far enough to hang up on nieghboring eyes, rail brackets, etc. I was fishing for something more idiot- or ham-fist-proof, but I suppose I could just be more careful??? Mike Mike & Jane Spalding spalding48@earthlink.net > [Original Message] > From: Ron Nossaman <RNossaman@cox.net> > To: Pianotech <pianotech@ptg.org>; <spalding48@earthlink.net> > Date: 5/22/2003 10:02:34 PM > Subject: Re: Inaccessible Let-off Screws > > > > Is there a > >tool I don't own yet, for adjusting let-off screws with low overhead > >clearance? Or do I have to run another hammer rail over the router table? > > > >Mike Spalding RPT > > > The tool you regulate capstans with (straight end/bent end) works fine. > > Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC