----- Original Message ----- From: "J Patrick Draine" <draine@comcast.net> To: "Pianotech" <pianotech@ptg.org> Sent: Sunday, October 05, 2003 1:46 PM Subject: Re: Reading a Board > > On Sunday, October 5, 2003, at 10:32 AM, Bill Ballard wrote: > > > At 11:59 AM +0200 10/5/03, Richard Brekne wrote: > >> Would you be doing your crown readings from on top of the soundboard, > >> or from underneath ? > > > > The underside is where it should be measured. > > So can I infer from that statement that all tapering of soundboards is > done on the top surface? So if I wanted to be anal, wouldn't the crown be measured from the center of the panel thickness?? Hmmmmm? Carl Meyer Ptg assoc Santa Clara, Ca. > Patrick Draine > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC