---------------------- multipart/mixed attachment -------------------------------1076278200 In a message dated 2/8/2004 9:08:01 AM Pacific Standard Time, Erwinspiano writes: Terry,David, Ron & Joe Thanks for the reply & suggetions. Terry I had feeling you'd have a fair bit of epoxy experience. I know that from Rons comment on it doesn't matter what's below the top is a credible reality but I,m going to fill the holes any way. Often I end up redrilling right into the same holes, so I've thought why bother but I like the idea of a tight hole for the pin thru out its length. I like davids suggestion of the toothpicks only I'd use the Non-gumming up bolduc glue insted of the tight bond. Stick em in, let em set up a bit,shave them off with a chisel, scrape the bride top, glue on the caps & ready to rock & roll. Ok I'll let you know how it turns out. Thanks to all for the suggestions Dale -------------------------------1076278200 An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/7e/74/c5/13/attachment.htm -------------------------------1076278200-- ---------------------- multipart/mixed attachment An embedded message was scrubbed... From: Erwinspiano@aol.com Subject: Re: Shoe pegs or epoxy to fill bridge holes Date: Sun, 8 Feb 2004 12:08:01 EST Size: 9366 Url: https://www.moypiano.com/ptg/pianotech.php/attachments/c5/4e/7b/74/attachment.eml ---------------------- multipart/mixed attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC