Piano Truck Installation

Michael Spalding spalding48@earthlink.net
Thu, 12 Feb 2004 07:46:40 -0600


Jon,

thanks for the clearly presented procedure.  And no, you have not been
repetitively redundant.  Each point was presented once, which is usually
sufficiently adequate enough.

regards,

Mike


> [Original Message]
> From: Jon Page <jonpage@comcast.net>
> To: <pianotech@ptg.org>
> Date: 2/12/2004 7:37:08 AM
> Subject: Piano Truck Installation 
>
> The 'truck stops' are also used when removing a truck.  Place the wedges
under the
> front legs and remove the rear leg from the truck.  The wedges will
prevent the rear
> arm from rising in the air (possibly nicking the leg).
>
> Of course, you might have gathered that from the 'installation'
description.
> I hope I'm not being unnecessarily redundant too much.
>
>
> Regards,
>
> Jon Page, piano technician
> Harwich Port, Cape Cod, Mass.
> mailto:jonpage@comcast.net
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ 
>
>
> _______________________________________________
> pianotech list info: https://www.moypiano.com/resources/#archives



This PTG archive page provided courtesy of Moy Piano Service, LLC