---------------------- multipart/alternative attachment At 4:57 PM -0400 7/25/04, Farrell wrote: >... when played very softly/slowly, the jack would not reset back >under the hammer butt. > Plenty of lost motion. ... Terry, Take the worst offender and remove the wippen from the action and verify that the wippen / jack flange center pins are free and not binding. Repin if unsure. On that same note verify for certain that the front / balance rail key bushings are not causing excess friction. These areas can be deceptive at times. Until it is determined without reservation that these areas are not contributing to the problem, adding and/or removing weights is the last resort. Sincerely, Keith -- Keith McGavern Registered Piano Technician Oklahoma Chapter 731 Piano Technicians Guild USA ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/73/3b/9b/23/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC