Carl, With a slight modification and a little practice, you can shape hammers at the same time. Thanks for the tip. Dave Davis --- Carl Meyer <cmpiano@comcast.net> wrote: > >> I spaced the hammer shanks up with a 5 inch board, > put an aluminum u > channel above and clamped with rubber bands. Then I > used the front round > end of a small hand held belt sander and with a > quickly learned technique > with the sander running, allowed the sander to climb > the tail to shape them > to the back check. I used a very coarse belt which > worked very well. It > even corrected the poorly hung hammers. Tails were > not in line very well. > __________________________________ Do you Yahoo!? Get better spam protection with Yahoo! Mail. http://antispam.yahoo.com/tools
This PTG archive page provided courtesy of Moy Piano Service, LLC