Jon, Are you talking about running a drill through the hole that already exists in the bushing? > [Original Message] > From: Jon Page <jonpage@comcast.net> > To: <spalding48@earthlink.net> > Date: 5/2/2004 7:36:34 AM > Subject: pinblock drilling angle, with pin bushings > > One way to avoid the misalignment problem is drill at an angle from the > underside > of the plate through the bushing at the tuning pin angle. Either install > the bushings > before the plate is installed or remove the plate after the bushings are > banged in. > > Or drill at the angle from the top if the block holes are not centered in > the bottom of the plate hole. > > Regards, > > Jon Page >
This PTG archive page provided courtesy of Moy Piano Service, LLC