You guys have too much time on your hands... David I. ----- Original message ----------------------------------------> From: Paul Chick \(Earthlink\) <tune4@earthlink.net> To: Mark Davidson <mark.davidson@mindspring.com>, Pianotech <pianotech@ptg.org> Received: Fri, 12 Nov 2004 18:13:10 -0600 Subject: RE: making key bushing cauls >Subject: making key bushing cauls >Various cauls available for sale, but I was considering making these using >either router or table saw and some appropriate machinable plastic. >Wondered if anyone had any tips (besides the obvious - "buy them"). >-Mark >I made a few sets before buying the brass cauls. The biggest problem I >encountered was holding the stock securely enough to maintain the the >correct thickness to + or - .001" I would like to know how you solve this >problem. I now have a vertical milling machine (almost set up) to handle >the accuracy for this kind of project. >Paul C >_______________________________________________ >pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC