Because all of those other centers are under enough weight/spring tension to oppose whatever binding there is in the flange. Thump --- Clyde Allen <tunepiano1@yahoo.com> wrote: > Dave, > Can you use denatured (wood) alcohol for this > application? Thanks. > > Clyde Allen, Assoc. > Silver Spring, MD > > Dave Nereson <davner@kaosol.net> wrote: > Went to tune a lady's Baldwin spinet (not Acrosonic, > but doesn't > matter) and after hitting the soft pedal, most of > the hammers drifted back > very slowly. It had changed climates and the action > centers were sluggish. > I've encountered this many times before. > But what I don't get is: why is it almost always > remedied by shrinking > only the hammer-butt center-pin bushings? Don't all > the other center pin > bushings swell as well (or flanges shrink, whatever > the case may be)? > I applied about 1:4 alcohol to water to all the > hammer flange bushings, > let it dry, and that freed them up pretty well, as > it usually does. Still > had to re-pin a few. But why aren't all the jacks, > wippens, and dampers > sluggish also? > --David Nereson, RPT > > > _______________________________________________ > pianotech list info: > https://www.moypiano.com/resources/#archives > > __________________________________________________ > Do You Yahoo!? > Tired of spam? Yahoo! Mail has the best spam > protection around > http://mail.yahoo.com __________________________________ Do you Yahoo!? Check out the new Yahoo! Front Page. www.yahoo.com
This PTG archive page provided courtesy of Moy Piano Service, LLC