I'm sure you could find one for sale...in fact I might be willing to sell my Hale tool. It's complicated, I never use it and frankly I just cut off the shank and drill in by eye using the adjacent hammer assembly for angle. David I. ----- Original message ----------------------------------------> From: Dave Nereson <davner@kaosol.net> To: Pianotech <pianotech@ptg.org> Received: Tue, 16 Nov 2004 00:39:40 -0700 Subject: Re: butt and hammer boring jig >----- Original Message ----- >From: "daniel carlton" <nannermail@hotmail.com> >To: <pianotech@ptg.org> >Sent: Monday, November 15, 2004 9:31 AM >Subject: butt and hammer boring jig >> is apsco the only one that ever made a butt and hammer boring jig, or did >> hale make one too? anyone know? i'm looking for a hale jig if they made >> one, new or used. >> >> thanks >> daniel carlton >Yes, Hale made one -- #208 on page 38 of the last Tuners Supply catalog. >I know, that does you no good. Don't know where you could get one, but they >do exist. --David Nereson, RPT >_______________________________________________ >pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC