This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Hi Julia, I have all the spoon benders that the companys make and none work as = well as the split screwdriver made to remove the key upstop rail brass = round nuts. Of course it takes just a little while longer as you must = lean the action back and use judgement to set the damper using its = closest neighbors as guides. But it sure is a whole lot less fustrating. Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com ----- Original Message -----=20 From: Alpha88x@aol.com=20 To: pianotech@ptg.org=20 Sent: Tuesday, November 16, 2004 10:15 AM Subject: spoon bender won't fit! Greetings, Is there any other way to adjust/calibrate spoons? I have a = Reinhard & Co. studio upright ca. 1900+ and the spoon bending tool will = not fit.=20 I can get the tool slid between the wippens okay, but when = I go to turn the tool sideways in order to get the neck of the spoon in = the tool head, I cannot. If I would turn the tool by force the wippen = flange to the adjacent note would crack. it is so tight in there, no = room. Can this job be done outside the piano? What to do? Any suggestions would be helpful.=20 Julia Gottchall,=20 Reading, PA ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/89/56/51/e3/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC