----- Original Message ----- From: <JIMRPT@aol.com> To: <pianotech@ptg.org> Sent: Tuesday, September 14, 2004 10:14 PM Subject: Re: Drill press > > In a message dated 15/09/04 4:02:40 AM, piano57@flash.net writes: > > << the laser trac that shows exactly where the bit will land. >> > > Barb the laser track thingee works very well 'if' you are drilling with the > same bit, inserted the same distance in the chuck, and drilling in the same > thickness material...otherwise it needs to be set up/adjusted/calibrated for each > use. Dang. I wanted a miracle! (I'd only seen ads for the press, hadn't actually gone to see it.) Thanks, everyone for your advice. Barbara Richmond
This PTG archive page provided courtesy of Moy Piano Service, LLC