Huh, Question ? I am still fixated on that little dot <G> Start by taking the measurments of all speaking lengths. Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com ----- Original Message ----- From: "Avery Todd" <avery@ev1.net> To: "Pianotech" <pianotech@ptg.org> Sent: Sunday, September 26, 2004 6:12 PM Subject: Re: George Steck > Ajay, > > Could you please put a comma, period, etc. SOMETHING > in there!? > > Avery > > At 07:31 AM 9/26/04, you wrote: > >Hello list am working on a George Steck upright its > >really big serial no 36196 here is what I found when I > >unstrung the piano found that the person who strung > >this piano before did not string it with proper piano > >steel wire it was one of the cheap wires available in > >the Indian market & now I do not have the steel wire > >scale for this piano can you please suggest as to how > >to go about it & if I follow the calculating > >Technician series for this then how do I start . > > It was a real nightmare to see a piano with > >such third grade wire & the piano sounded horrible > > > > With warm regards > > Ajay. > > > >===== > >Ajay Mistry > > > >________________________________________________________________________ > >Yahoo! India Matrimony: Find your life partner online > >Go to: http://yahoo.shaadi.com/india-matrimony > >_______________________________________________ > >pianotech list info: https://www.moypiano.com/resources/#archives > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC