This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment I forgot. Put down that belt sander. It would take you a week. BTW = Right angle die grinders runs from air. Carl Meyer PTG assoc Santa Clara, Ca. ----- Original Message -----=20 From: Alan & Carolyn Barnard=20 To: Pianotech List=20 Sent: Wednesday, April 27, 2005 12:54 PM Subject: Anyone done this? Tiny, crappy grand. Someone did major repairs(?) to ribs, soundboard, = etc. A real hatchet job with great globs of epoxy ... They replaced the block and restrung it not too badly except they used = a block so thick that you can't get the action out without tilting it = and I still snapped off one bass hammer. Drop screws barely clear when = the action is in. Measured the depth of holes to bottom of pins and it's almost an inch! Any reason one couldn't take a belt sander to the underside of that = board and grind off about a 1/4" in the bass, 1/8" in tenor and treble? = No room for a router. Alan R. Barnard Ready to Sand, Sander in Hand in Salem, Missouri ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/8f/f3/b7/72/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC