This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Hello Fenton A remarkable and inventive solution which could, presumably, be extended = into aligning new hung hammers - non? Regards from a snowy Sussex - Maxim (7yrs) and I made two snowmen before = breakfast... Michael G.(UK)=20 ----- Original Message -----=20 From: Fenton Murray=20 To: pianotech@ptg.org=20 Sent: Sunday, February 27, 2005 5:48 AM Subject: jigs & fixtures I have posted pictures to a simple jig I made to align upright dampers = after replacement of levers. I later cut away even more Plexiglas below = the felt to enable all wire bending to be done from the back. This is = very convenient when the piano is not in the shop. Upon return = everything is pre-aligned. String grooves are marked with a Sharpie = before tear down. I think the rest is self explanatory. I can't seem to view photos on the list so I've provided a link to = photos below. Write me off list if you have questions, that will leave = room for others to continue this thread with more ideas.=20 http://www.murrayspianotuning.com/id172.htm Fenton Murray, RPT ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/65/5a/9f/c1/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC