Hi, On a side note, what type of glue is best for a quick gluing of a rib that may be loose from the soundboard (as the result of a crack)? And then, what are the best solutions for this, minus replacing the soundboard? -- John > Why not just do a Spurlock-type shim job right up to both sides of the > bridge? If there is a small area where the bridge is not glued to the > panel, put some glue in there and block up the panel from behind and > go bar on top - or use a rib gluing boat before shimming (but instead > of gluing on a rib you will be gluing on the bridge). > > Make sense? > > Terry Farrell
This PTG archive page provided courtesy of Moy Piano Service, LLC