This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Hi Cy, Why take the chance when a few drops of CA will do the same thing, and = leave the pin where it will render the same as its partners? Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com ----- Original Message -----=20 From: Cy Shuster=20 To: Pianotech=20 Sent: Sunday, May 22, 2005 6:40 AM Subject: Tapping grand pins unsupported? Is it OK to give a few taps to a loose tuning pin without pulling the = action and supporting the block? Clearly, support is necessary when driving a pin into an empty hole. = But I've run into a few grands that have just two or three loose pins = and plenty of coil height. It's so much quicker to give them two or = three taps with my Handy Hammer (side note: the combination handle grips = only *twisting* tools!), rather than bringing out the CA... --Cy Shuster-- Bluefield, WV ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/82/14/2a/0f/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC