This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment There is a flat spot on the bottom of the rail, but if you back the = screw off to where the old button falls off and then hold the new button = against the bottom of the rail and start the screw with a combo handle let-off = tool inserted into an electric screwdriver or light cordless, you can get = them started pretty straight. Let go of the button and let it take a few = turns to see if it's rotating square-assuming the screw isn't bent. =20 =20 David Love davidlovepianos@comcast.net=20 -----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On = Behalf Of Clark Sprague Sent: Monday, October 10, 2005 6:31 PM To: Pianotech Subject: Let-off Buttons =20 =20 I know that there was a thread a while ago on how to install new let-off buttons to get them on square, but has anybody got a trick on how to = get them square on Steinway grand rails? They are not flat on the bottom, = so holding them tight with your fingertip does not guarantee having them = start on straight. Any ideas? Clark A. Sprague, RPT ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/35/59/80/ce/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC