This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Radial arm chop saw Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com ----- Original Message -----=20 From: Matthew Todd=20 To: Pianotech=20 Sent: Thursday, September 01, 2005 9:51 PM Subject: Keytops botched - ANOTHER QUESTION. Thanks in advance! When I did my keytops, the old tops were about .040 on the micrometer. = The new tops I installed, were .080. I was using a router to rout off = the difference. What ways to you all use? Is there some sort of = conversion table to use for measurements? Matthew -------------------------------------------------------------------------= ----- Start your day with Yahoo! - make it your home page ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/65/ac/70/4e/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC