---------------------- multipart/alternative attachment Bill I'm doing the same currently & its' not an hours work to do this on a table saw & drill press. I do change the tray pivotsto be in line with the underlever centers, which can take some time, but that's the nature of custom mods. Dale The new underlevers are 10.9mm longer than the original 1973s. Adapting the original tray to mount the new levers (so that the lever/post center stays put) appears to be three zips across the tablesaw (plus deepening the existing flange screw holes). This is a perfectly good tray and modifying it certainly isn't $400 worth of labor. Mr. Bill ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/46/05/35/a1/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC