thumping dampers

richard.ucci@att.net richard.ucci@att.net
Tue, 10 Jan 2006 20:36:55 +0000


---------------------- multipart/alternative attachment
Thanks Dean, 
I'm sure this Yamaha has a stop screw, and I'll follow your advice.

Rick Ucci/Ucci Piano

-------------- Original message from "Dean May" <deanmay@pianorebuilders.com>: -------------- 


To minimize thumping dampers you should minimize their travel. There should be a stop screwed into the keybed directly above the pedal lift rod. Adjust the stop down until the bicord dampers are just coming off the string. To adjust it really “hot” the bottoms of the bicords do not have to clear the top of the string- leave some of the wedge down between the strings. 
 
As you minimize the lift off the strings you are also minimizing the dampers’ return velocity, which will also minimize the thumping. 
 
BTW, if there is no stop screw there, just put one in. A 1/4 X 1 inch hex bolt works great. Drill a hole in the keybed and thread the bolt into it. Glue a piece of felt on top of the trapwork lever and, viola, you have a stop adjustment. 
 
Dean
Dean May             cell 812.239.3359
PianoRebuilders.com   812.235.5272
Terre Haute IN  47802
 
-----Original Message-----
From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On Behalf Of James Grebe
Sent: Tuesday, January 10, 2006 8:25 AM
To: Pianotech
Subject: Re: thumping dampers
 
Move the mic further away from the dampers.  Most place it too close.
James
James Grebe   Piano Tuning & Repair   Member of M.P.T.  
R.P.T. of the P.T.G. for over 30 years.   "Member of the Year" in 1989
   Creator of Handsome Hardwood Caster Cups, Piano Benches, Writing Instruments
(314) 845-8282   1526 Raspberry Lane   Arnold, MO 63010
BECOME WHAT YOU BELIEVE!
pianoman@accessus.net
----- Original Message ----- 
From: richard.ucci@att.net 
To: pianotech@ptg.org 
Sent: Monday, January 09, 2006 7:59 PM
Subject: thumping dampers
 
Hi Listers,
 
Client with a new Yamaha ga-1 is complaining that the dampers make a thumping noise when his foot is taken off the sustain pedal. He is doing some recording and it is very noticable to him. Other than changing the spring to one with less tension , what would be a solution to his problem?
 
Thanks,
Rick Ucci/Ucci Piano 
---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/07/e2/98/47/attachment.htm

---------------------- multipart/alternative attachment--

This PTG archive page provided courtesy of Moy Piano Service, LLC