Acrosonic puzzler

Joe And Penny Goss imatunr at srvinet.com
Fri Jun 2 12:07:29 MDT 2006


Hi Phil,
Fustratin isint it.
Without being able to see what you are faced with it is impossible to guess
what the correct answer might be.
I would suggest going to one side of the piano and looking at the opposite
side with the help of a flash light. Look for evidence of a snap spring or
capture devise of some sort.
You may only be able to see the screws or rim or edge of whatever they used.
Joe Goss RPT
Mother Goose Tools
imatunr at srvinet.com
www.mothergoosetools.com
----- Original Message ----- 
From: "Phil Bondi" <phil at philbondi.com>
To: "Newtonville" <pianotech at ptg.org>
Sent: Friday, June 02, 2006 11:23 AM
Subject: Acrosonic puzzler


> Hi all.
>
> I ran across one this morning that truly had me losing a bit more
> hair..circa 1967, and I think that may be significant simply because of
> all the Acros I have seen over the years, this one was unique.
>
> I could not figure out how to remove the music desk - fallboard/keycover
> apparatus.
>
> This hunk of wood had 2 screws at either end of the music desk, located
> very close to the wire..closer than I have ever seen..and..the key cover
> sho nuff seems to be attached to this music desk. This is the kind that
> folds back nicely.
>
> Upon removing the 2 screws I mentioned above, there was still no 'give'
> to this hunk of wood. Looking under the keybed, I saw 4 screws on either
> side of the bed. Upon removing the screws from one side of the bed, that
> side that should now be loose still was not.
>
> There were no buttons on the cheek blocks hiding any screws..besides,
> isn't that method reserved for Grands??
>
> I am baffled on how this hunk of wood is to be removed, so go
> ahead..make me feel dumb.
>
> -Phil Bondi(Fl)
>



More information about the Pianotech mailing list

This PTG archive page provided courtesy of Moy Piano Service, LLC