Horugel parts

[mps at usol.com]

Dear Isaac,

I did the repair as you suggest and it worked wonders. There was a 
need to replace some of the leather up in the trap workings but the 
buckskin fit the bill to replace those old worn-out rubber grommets. I 
did notice however that you must be a bit careful not to have the rods 
fit in too tight. Otherwise a different squeak develops. This was 
success!!!

Thank you!
Mark

> Hi,Mark! Here is a simple solution and repair far superior 
then "RUBBER
> GROMMETS".. Take 2 pieces of leather or buckskin a little wider then 
the
> width of backcheck strips,lay them across in the pedal rod hole in 
the
> pedal,press fit with pedal rod,trim with the razor blade-you are 
done.The
> leather or buckskin will outlive any rubber and will never sqeak.This 
repair
> is also applicable on Steinways and many Asian pianos. Try it-You 
will like
> it..Let us know how it works.. Best of luck.. Isaac
> 
> -----Original Message-----
> From: pianotech-bounces at ptg.org [mailto:pianotech-
bounces at ptg.org] On Behalf
> Of mps at usol.com
> Sent: Monday, May 22, 2006 9:52 AM
> To: pianotech at ptg.org
> Subject: Horugel parts
> 
> Hello friends,
> 
> Could anyone help direct me to where I could purchase parts for a 
> Horugel Grand?
> In particular, the grommets at the base of the pedal rods.
> 
> Thank you 
> Mark's Piano
> Service
>