Chinese based Heintzman

[Ron Nossaman]

> Perhaps I used the wrong term, but I bet they are apt to lean a whole lot
> more when an (it looks like 1/8" ) is sticking out the bottom of the pin
> hole.

Hi Joe,
Actually no, they aren't more likely to lean, even if the 
rounded end didn't extend over 1/8" down beyond where the 
threads contact the block. Look at the photo again, and note 
the shadow around the complete perimeter of the bottom of the 
hole in the block. That means that the threads at the bottom 
of the pin are all well inside the block.

Ron N