Epoxy Finish for the Board.

[ed440 at mindspring.com]

Bill-
One side will do.
Check Del's articles from about 3 years back.
Ed Sutton

-----Original Message-----
>From: william ballard <yardbird at vermontel.net>
>Sent: Mar 23, 2006 10:58 AM
>To: Pianotech List <pianotech at ptg.org>
>Subject: Epoxy Finish for the Board.
>
>The answer is probably obvious, but I thought I'd ask it any. When  
>doing the epoxy treatment for an older board, does this necessarily  
>mean stripping, preparing and finishing both sides of the board.  
>(Speaking as one for whom varnishing a board was always a cosmetic  
>step, and thus only necessary on the top side........)
>
>Bill Ballard RPT
>NH Chapter, P.T.G.
>wbps at vermontel.net
>
>"There are fifty ways to screw up on this job. If you can think of  
>twenty of them, you're a genius......and you aint no genius"
>     ...........Mickey Rourke to William Hurt, in "Body Heat",  
>discussing arson.
>+++++++++++++++++++++