Dittos. Good suggestion. I do this to many plates. Especially Steinway to prevent the pins from possibly leaning into the plate hole itself. Dale Bob, I'm not an expert, but I'd say if there is room (and I suspect there is) just drill out the plate to enlarge the existing tuning pin holes in the plate to whatever size bushing you wish to use. Regards, William R. Monroe -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060516/68d79108/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC