Grand hammer shaping.Hi, This is sometimes why one side of the flange is consistantly looser than the other? Joe Goss RPT Mother Goose Tools imatunr at srvinet.com www.mothergoosetools.com ----- Original Message ----- From: Christopher Thomas To: Pianotech List Sent: Wednesday, May 17, 2006 8:57 AM Subject: Grand hammer shaping. In shaping new hammers in the bass section with respect to clearance between the adjoining hammers, it .appears that the hammers require shaping on one side (bass side) to acheive clearance. Is there any concern by the imbalane about the shank axis? Although the hammers are skewwed, is there any need to shape the hammer tail on the opposite side? -----Original Message----- From: Jon Page [mailto:jonpage at comcast.net] Sent: Tue May 16 22:34:05 2006 To: pianotech at ptg.org Subject: Gulbransen spinet whippen needed If there is no way to repair the old wippen... Take the wippen off A#7, install the damper spoon from the old wippen. The reason for A#7 is that it won't be missed. Even if someone were to compulsively push down keys at the top end, they would play the white keys. -- Regards, Jon Page -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060517/ebb0f216/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC