Hear, here, I've done the same thing, less de-tensioning. It works, not pretty, but those school pianos will last a little longer... Andrew Anderson At 07:21 PM 5/23/2006, you wrote: >This phenomenon is fairly common, unfortunately, on the hamilton >studios--at least I've seen several. The tip-off is when you play >notes and it sounds like a drummer hitting his hollow wood blocks! > >I don't know about doing this to a newer piano, but what I've done >is take the tension down on every other unison in the affected area, >drilled and countersunk screw leads through the cap and into the >bridge, worked glue into between bridge and cap, put in some sturdy >screws, i.e., screws from junked pianos not the crap they sell >nowadays, and torqued the sucker down. > >I don't know what effect the additional bridge mass has because it >just sounds so much better without the woody "bonk" and with the >energy now being transferred, sustain and power are, of course, >dramatically improved. I tune up the piano, leave the screws in >place, and go on about my merry way. > >Alan Barnard >Salem, Missouri > > >----- Original Message ----- >From: <mailto:mfarrel2 at tampabay.rr.com>Farrell >To: <mailto:pianotech at ptg.org>Pianotech List >Sent: 05/23/2006 5:52:17 PM >Subject: Re: baldwind bridge separation > >I thought Baldwin was using vertically laminated bridges with no >bridge cap. Or is that only on their grands? > >If it is the cap pulling off, I should think that such a new piano >is worth removing the necessary strings and gluing the cap back down >(epoxy might be best). Likely will have to remove bridge pins also. >Also, keep in mind that if a couple inches of cap is visibly pulling >away from the root, I wonder how well the rest of the cap is >attached (may want to remove entire cap and reglue/rebond). What is >downbearing like in that area? Seems to me that even if the cap were >not glued well, it would tend to be pushed into the root by >downbearing pressure. I'd recommend taking a very close look to see >what is going on. > >Terry Farrell >----- Original Message ----- >I went to look at a ca: 2000 Baldwin console , black high polish, >today for a dealer. The treble bridge cap was pulling away at keys >48-59, resulting in a very plunky tone. I'm told that Gibson/Baldwin >no longer backs the warranty on instruments sold before the >takeover. Is this true, and also ,is this the kiss of death for this >piano? Can a permanant repair be made? >Thanks, >Rick Ucci/Ucci Piano -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060523/ce810c12/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC