I am about to do my first -all new- butt, shank and hammer job The shanks I bought are 7/32" and the hammers were bored for that size. I just received the new butts and to my suprise the bored hole in the butts are bigger than my 7/32" shanks. When I put the shanks in the butts there is wiggle room. This doesn't seem right! The butts are made by Tokiwa and they are for a brass rail. Is this normal? Or should I return them and ask for butts bored for 7/32" shanks? When I looked in the Schaff catalog to see if shanks are made bigger than 7/32" I could not find anything butt shanks drills that were for sizes smaller than 7/32". I'm confused...please help. Thanks, Ed _________________________________________________________________ Find a local pizza place, music store, museum and more then map the best route! http://local.live.com?FORM=MGA001
This PTG archive page provided courtesy of Moy Piano Service, LLC