Or, of course, convert brass rail to wooden flanges, ala Bill Spurlock.... Terry Farrell ----- Original Message ----- From: "Joseph Garrett" <joegarrett at earthlink.net> To: "pianotech" <pianotech at ptg.org> Sent: Tuesday, November 21, 2006 8:43 PM Subject: Re: Traveling Brass Rail Butts >I don't believe you can travel brass butts. You have to use your electric > shank bending piers to travel and align the hammers to the strings. > > There is a way, but you won't like it.<G> Take the butt out and bend the > center pin in a dog-leg fashion. It is extreme and only for extreme > circumstances. The proper thing to do is remove the hammer/shank and > re-install it so that the hammer is centered on the unison, IMO. > > > Joseph Garrett, R.P.T. > Captain, Tool Police > Squares R I > >
This PTG archive page provided courtesy of Moy Piano Service, LLC