I just happen to take a glance at pianotech, and what do I see? They are still talking about hammers...... Apparently an issue one never gets tired of....... OOR On 13-okt-2006, at 19:54, David Love wrote: > Sample, sample, sample. > > > David Love > davidlovepianos at comcast.net > www.davidlovepianos.com > > -----Original Message----- > From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] > On Behalf Of Farrell > Sent: Friday, October 13, 2006 9:02 AM > To: pianotech at ptg.org > Subject: New Hammers on Old Piano > > > I'm rebuilding a WNG action for a 100-year-old Julius Bauer grand - > about 6-foot. This is the one with the lightly-built case, and > plate that looks like it should be the frame for an army tank. It > also has the soundboard with ribs on both sides. The belly is all > original, in very good condition, and will be getting new damper > felt and bass strings. > > > I'm looking for recommendations for new hammers. I've been using > mostly softer cold-pressed hammers, but those are for Del-Fandrich- > designed bellies. I suspect this soundboard differs significantly > from a Del-design - and as such, may well do better with a > different type of hammer. I've used Abel Lights with much success > on original-bellied old American pianos in the past (S&S, Baldwin, > others), and left unguided, I might be inclined to go with them - > just thinking that the soundboard is likely not as efficient as a > Fandrich-design and might benefit from the firmer hammer. > > > Anyone have any thoughts on this matter? Thanks. > > > Terry Farrell > > > BTW: This piano is absolutely amazing. I have never seen a more > finely constructed piano. The plate must have twice or more the > cast iron that a similar-sized Baldwin or S&S would have. The > pinblock is surrounded on five sides with cast iron - only the > bottom is open. The belly rail is arched - like a full inch - to > induce a crown into the soundboard. So many unusual features - the > lack of wooden rim (only a small one) and complete lack of rim > bracing - and the way the plate is the entire structural component > of the piano - this is really a cast-iron piano with a decorative > wooden case. If you enjoy studying piano design and construction, > you really need to go through one of these very fine pianos. > > -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20061013/b62c2f94/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC