Why not use a coved out sanding block with the sanding cloth. Would that work? GM ----- Original Message ----- From: "David Ilvedson" <ilvey at sbcglobal.net> To: <pianotech at ptg.org> Sent: Sunday, December 09, 2007 6:05 PM Subject: RE: capo work > When I file I run the file the length of the capo in one stroke, then the > other side...trying to be even (as best I can in close quarters) > > David Ilvedson, RPT > Pacifica, CA 94044 > > ----- Original message ---------------------------------------- > From: "John Delacour" <JD at Pianomaker.co.uk> > To: "Pianotech List" <pianotech at ptg.org> > Received: 12/9/2007 3:00:04 PM > Subject: RE: capo work > > >>At 14:16 -0800 9/12/07, David Ilvedson wrote: > >>>The scraping idea is intriguing...although I've never found cast >>>iron hard to file... > >>No, nor have I, but to achieve a perfectly regular 2mm or other >>radius along the length of the bar using files strikes me as a bit of >>a challenge. > >>JD
This PTG archive page provided courtesy of Moy Piano Service, LLC