Yes, that's the pin. The resistance should be measured at the drop screw pad, with the spring being held so it's not affecting the lever. 10-grams there is probably tops but 8 is really a nice number. dp David M. Porritt dporritt at smu.edu ________________________________ From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Danilo Perusina Sent: Wednesday, June 20, 2007 8:42 AM To: pianotech at ptg.org Subject: RE: Keep on filing...(picture attached) David, to avoid misunderstanding, are you referring to this pin: (see attached picture, cut from concertpitchpiano.com) If so, where along the length of the lever should I measure 8-10 grams? Thanks, Danilo ________________________________ From: "Porritt, David" <dporritt at mail.smu.edu> Reply-To: Pianotech List <pianotech at ptg.org> To: "Pianotech List" <pianotech at ptg.org> Subject: RE: Keep on filing... Date: Wed, 20 Jun 2007 06:18:11 -0500 Danilo: If the repetition lever spring can not be regulated to function properly it sounds to me like the pinning is too loose. The repetition lever should have 8 - 10 grams friction. Then the spring can be regulated strongly enough without the big jump of the hammer. If this is the case, even new hammers won't cure that problem. Re-pin the repetition lever and I think you'll be able to regulate it. dp David M. Porritt dporritt at smu.edu ________________________________ From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Danilo Perusina Sent: Tuesday, June 19, 2007 6:54 PM To: pianotech at ptg.org Subject: RE: Keep on filing... Hi! Dean, Tony and David, thanks for your input! I thought the very same, that since these parts need to be replaced, I can use whats left of them to educate myself further. The aim, of course, is to make them perform better. Born out of necessity, actually, a recording session in the middle of the night, not the best time to call a technician! But that was two years ago, and a lot of "seeing and feeling" since then, as well as self-studying and asking technicians that I've met. Parts that need replacement will not respond ideally to being regulated, I guess. This is where the spring tension comes in. I did actually start working on them, and it was then that this problem arose. They are quite tense now, and it indeed causes some hammers to double-blow on the strings. And when I ease them up so that the hammer rises gently when released from check, the jack starts to not wanting to return under the knuckle properly. I was convinced it was due to the reduced weight of the hammers, but you've made me not so sure of that anymore. Knuckles need lubrication? (and replacement?) Spring needs to be cleaned perhaps? By the way, how would you diagnose that a spring needs to be replaced (unless broken of course)? Yes, a mentor would be very welcome, and excuse any language errors, english is not my native tongue. Very glad to hear about your background, Tony! Regards, Danilo ________________________________ Smaka på vårens godbitar! Fräscha middagstips på MSN <http://g.msn.com/8HMASVSE/2746??PS=47575> ________________________________ Smaka på vårens godbitar! Fräscha middagstips på MSN <http://g.msn.com/8HMBSVSE/2746??PS=47575> -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20070620/74d80c18/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC