> <What pins are you using, that you get that much variation? > > Denro nickel and blued. What do you use, and how much variation do you get. > These Denros are inconsistent top to bottom as well. I use the Denro blued. Since I started using the composite block, I haven't bothered micing pins, and the torque uniformity is the best I've ever gotten. > <Since I started using the 9mm Delignit capped maple multilam composite, I get higher final > <torque with the 6.8mm second pass than I did with Delignit. > <The bit mic's the same, so it's not wearing down smaller, > <otherwise I don't know why that is. > <Ron N > > That's interesting. Counterintuitive, but consistent...something secret is going on the > hole. I wonder if the .282 pins are large enough that they are shearing fibres as they go > in, while the lighter pins are compressing fibres. No clue, but I'll take it. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC