Greetings kind folk, Im hoping that someone out there in cyber land can help me today. I have the task of thickness trimming on some prehung hammers from S&S. The hammers came too thick for the vintage grand Im working on as there is not sufficient clearance to allow reliable individual hammer movement. Ordinarily I would do this before hanging hammers but since these are pre-hung . well Im a bit stuck. Does anyone know of a jig that could be built that would accommodate trimming with the shanks on? The archives seem to point to something from Roger Jolly but the posts I read were not conclusive that one exists. Help?!? Greg Newell Greg's Piano Forté www.gregspianoforte.com 216-226-3791 (office) 216-470-8634 (mobile)
This PTG archive page provided courtesy of Moy Piano Service, LLC