Fred Brown III wrote: > Great looking rig! I'm sold. Where do you run the compressed air and did you > drill channels in the base to distribute the air. I actually have that same > model radial drill press so I would really like to copy the > design[Ronocraft]. > Fred Brown RPT > Atl GA The air goes into one hole in the middle of the base, controlled by a regular low tech chip blower you'd use in the shop to clean off the saw. The base is flat. No channels needed. The attached PDF is pretty fuzzy, but the file is small, and you can still tell what's what. Ron N -------------- next part -------------- A non-text attachment was scrubbed... Name: Drilling Pinblocks In The Piano.pdf Type: application/pdf Size: 57279 bytes Desc: not available Url : https://www.moypiano.com/ptg/pianotech.php/attachments/20080831/d8228e7b/attachment-0001.pdf
This PTG archive page provided courtesy of Moy Piano Service, LLC