On Fri, Dec 19, 2008 at 4:40 PM, Ron Nossaman <rnossaman at cox.net> wrote: > William Monroe wrote: > >> Andrew, >> >> How would you go about moving the duplex bar? >> >> William R. Monroe >> > > Like Ron O said, with an angle grinder, then build it back up level and > install something that works. This is my approach, also wonderfully clean > and very easy to fabricate. > Ron N > I'll vouch for it being "wonderfully clean." My Mom's "Steinway" M you did has a beautiful treble. What do you do to "build it back up level"? I know brass half round, but anything else below that? I also noticed on Mom's M that you filled the middle tuning pin holes where you changed the trichords to bichords (above the tenor break). With what do you fill those? -- JF -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech_ptg.org/attachments/20081219/24013637/attachment.html>
This PTG archive page provided courtesy of Moy Piano Service, LLC