straight-mate

[Isaac Sadigursky]

Hi,Jon! Strigh-Mate is available from Bob Marinelli... Regards..isaac

-----Original Message-----
From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf
Of Jon Page
Sent: Monday, February 18, 2008 11:10 AM
To: pianotech at ptg.org
Subject: straight-mate

I think it's Strat-Mate. If it is out of production you could make one
with a spinet caster and a piece of scrap pin block or 2X4.  i prefer
the caster iteration because of the larger area wheel pressing on the wire.
-- 

Regards,

Jon Page