mortise inserts slideshow

MICHAEL MORVAN keymaestro at verizon.net
Wed Feb 20 11:22:01 MST 2008


Clear DayFenton,
    I wouldn't get a wobbler, my father-in-law had one and it cut unpredictably, I have a nice stackable set, it cuts clean and straight, if you use the table saw make sure your crosslide/t-square is exactly 90 degrees to the saw blade and that the saw blade is 90 degrees to the table, your only as accurate as your setup.  Good  luck,   Mike
  ----- Original Message ----- 
  From: Fenton Murray 
  To: Pianotech List 
  Sent: Wednesday, February 20, 2008 12:12 PM
  Subject: Re: mortise inserts slideshow


  Any particular brand/type of dado you'd recommend. My early experience with wobblers turned me off to them and I've never used them since. 
  I assume you end up with a flat, machined, glue joint ready surface left behind by the dado. If that's the case I can see a future for them with me.
  Thanks,
  Fenton
    ----- Original Message ----- 
    From: Jude Reveley/Absolute Piano 
    To: Pianotech List 
    Sent: Tuesday, February 19, 2008 8:17 PM
    Subject: Re: mortise inserts slideshow


    Question: I know I could use a router instead of a dado blade for stock removal, but I just can't help but think of nasty tearout in that key with the dado set up. I assume you don't have that problem, do you use it simply for fast removal reasons? 
    Fenton

    Hi Fenton,

    I just recently tried out the dado for a set of balance hole inserts and found there was way less tear-out than with a router. I was very pleased; didn't even have to back the work up. You also have more options for the width by adding or subtracting dado shims.

    Nice work, Mike!

    Jude Reveley, RPT
    Absolute Piano Restoration, LLC
    Lowell, Massachusetts
    (978) 323-4545
      ----- Original Message ----- 
      From: Fenton Murray 
      To: Pianotech List 
      Sent: Tuesday, February 19, 2008 10:44 PM
      Subject: Re: mortise inserts slideshow


      Mike,
      I figured out the slide show, I didn't scroll down far enough on the page. I'll be ordering soon off your site. Great photos, thanks for your time in this. 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20080220/b19d456d/attachment-0001.html 
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/jpeg
Size: 5675 bytes
Desc: not available
Url : https://www.moypiano.com/ptg/pianotech.php/attachments/20080220/b19d456d/attachment-0001.jpe 


More information about the Pianotech mailing list

This PTG archive page provided courtesy of Moy Piano Service, LLC