Yeah, I use a variety of common locator indices for bridges, ribs, and panels, too. So far I haven't lost any of my templates. Let's see, where's some wood to knock on... P -----Original Message----- From: Ron Nossaman <rnossaman at cox.net> To: Pianotech List <pianotech at ptg.org> Sent: Mon, 9 Jun 2008 8:21 pm Subject: Re: Henry Miller-reprise ? > For years, I've been creating two small clear plexi templates with index > holes drilled through to a drilled "dimple" on the front flange of the > plate at the bass end and treble end. The plastic is 3/16" x 3" x 2" and > is fitted to the rim and stretcher in the corners before making the > index. The dimples are almost invisible if you don't know they're not > supposed to be there. I used to do what you're describing and what Ron > says he does until coming up with this way. You only need two points of > the "triangle" to locate the plate again.? > > Paul? ? I like the locator pins for a couple of reasons. If I don't intend to move the plate, they get it back where it was without me having to figure out where I misplaced the templates, and the already rebuilt action will work without a lot of drama. These same locators also index the soundboard panel when I locate the ribs on the panel from the mortises, and the rib and panel assembly when I locate the bridges from the plate, which is on the same set of pins so it will all go back together at the end just like I had it set up - if the soundboard assembly isn't at a significantly different MC when I install it. Or maybe I just like drilling holes in plates, since I sure do plenty of that.? ? Ron N? -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20080609/8a373b69/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC